Mitsubishi Fuso FK 2008, Owner'S Manual

Page: 209 / 355

12-58
Simple inspection and service
3 Braking performance
Perform braking tests in a safe place. After check-
ing that warning lamp or is not illuminated,
drive the vehicle at a low speed to make sure that
braking power is sufficient and even. If braking
seems in any way abnormal, operating the vehicle
could be dangerous. Ask an authorized dealer for a
more thorough inspection.
Use the air pressure gauge to check compressed
air pressure. The gauge should indicate a pressure
in range .
Also, make sure that the air pressure builds up at
the proper rate. This can be checked as follows:
1. Set the parking brake and stop the engine.
2. Open the drain cock to release all compressed
air from the air tank.
3. Start the engine and run it at idling speed while
timing how long it takes for the pressure to
reach 100 psi. The time should be as indicated
below.
Inspection
intervals
At the time of pre-operational
check and every 10,000 km
(6,000 miles)
WARNING
Perform brake tests in a safe place that
allows for good visibility all around. During
the tests, be attentive to surrounding traffic
conditions.
Air pressure – check
Inspection
intervals
At the time of pre-operational
check
Air pressure buildup time
[until 100 psi is reached from 0 psi]
FK61F Within 6 minutes
Other than FK61F Within 9 minutes
Z12028
Z17349
Z17350
FKFM.book Page 58 Wednesday, June 6, 2007 11:43 AM