Mitsubishi Fuso FK 2008, Owner'S Manual

Page: 191 / 355

12-40
Simple inspection and service
8. Remove the element and the sensor from the
filter case.
9. Replace the O-ring and O-ring with new
ones. Apply a thin coat of engine oil to each of
the new O-rings and install the O-ring on the
filter case and the O-ring on the sensor.
CAUTION
Use the O-rings that are supplied with the new
replacement element.
10. Clean the surfaces of the filter head and fil-
ter case that will come in contact with the O-
ring .
11. Install the element with the hole of its end facing
upward. Be sure to use a genuine replacement
element.
CAUTION
•
When installing the filter case, be careful not
to let the O-ring twist and be damaged.
•
Do not reuse the element.
12. Install the filter case by turning it in the direction
of the arrow . Tighten the filter case using the
special tool and a torque wrench to within the
following torque range.
Tightening
torque
30 ± 2 N·m (22 ± 1.5 ft.lbs.,
3 ± 0.2 kgf·m)
Z12117
Z11924
Z12286
FKFM.book Page 40 Wednesday, June 6, 2007 11:43 AM