Mitsubishi Fuso FK 2008, Owner'S Manual

Page: 258 / 355

13-19
CAUTION
Blown bulbs should be replaced as soon as
possible.
1 Replacing headlamp
•
Removal
1. Tilt the cab.
2. Remove the cover by turning it counterclock-
wise until it stops.
3. Remove the connector .
4. Remove the spring and then pull out the bulb
.
•
Installation
1. Install the bulb while aligning its bosses with
the cuts in the headlamp body, and then
install the spring to hold the bulb in place.
2. Install the connector.
3. Clean the packing if dirty.
Check the packing for twisting and correct it if
necessary.
4. Fit the cover while aligning its mark with
the boss (removal position index) on the
headlamp body, then rotate the cover clockwise
until the mark points at the other boss (lock
position index) .
5. Lower the cab back to its original position.
Front side turn signal lamp
<FK61F>
12V-10W (R10W) 2
Front side turn signal lamp
<Other than FK61F>
Identification lamp 12V-7.5W (#89) 3
Stop/tail lamp 12V-21/5W (P21/5W) 2
Rear turn signal lamp 12V-21W (P21W) 2
Backup lamp 12V-21W (P21W) 2
License plate lamp 12V-7.5W (#89) 1
Clearance and side marker lamp 12V-7.5W (#89) 2
– Interior lamp/personal lamp 12V-10W 2
Ref. No. Lamp Bulb wattage (bulb type) Q’ty
Z13637
Z13984
FKFM.book Page 19 Wednesday, June 6, 2007 11:43 AM