Mitsubishi MOTORS Outlander Sport 2018, Owner'S Manual

Page: 156 / 353

Rear-view camera
Features and controls 5-93
5
wheel replacement is not done by an autho-
rized Mitsubishi Motors dealer, it is not cov-
ered by your warranty.
N00533001246
Your tire pressure monitoring system oper-
ates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
(For vehicles sold in U.S.A.) and Industry
Canada Rules (For vehicles sold in Canada).
This device complies with part 15 of FCC
Rules and Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
N00546201343
When the gearshift lever or the selector lever
is in the “R” position with the ignition switch
or the operation mode is in ON, the rear-view
image will be displayed on the screen of the
Smartphone Link Display Audio or the DIS-
PLAY AUDIO in the center panel.
When the gearshift lever or the selector lever
is shifted out of the “R” position, the rear-
view image will go off.
The rear-view camera (A) is in the liftgate, at
the left side of the liftgate handle.
CAUTION
 The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting air leakage or damage of
the sensors.
General information
CAUTION
 Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
Rear-view camera
WARNING
 Never rely solely on the rear-view camera
to clear the area behind your vehicle.
Always check visually behind and all
around your vehicle for persons, animals,
obstructions or other vehicles. Failure to
do so can result in vehicle damage, serious
injury or death.
 The rear-view camera is an aid system for
backing up, but it is not a substitute for
your visual confirmation.
 The view on the screen is limited, and
objects outside the view, such as under the
bumper or around either corner of the
bumper end, cannot be seen on the screen.
Location of rear-view camera
CAUTION
 If the camera lens gets dirty, a clear image
cannot be obtained. As necessary, rinse the
lens with clean water and gently wipe with a
clean, soft cloth.
 To avoid damaging the camera;
• Do not rub the cover excessively or polish
it by using an abrasive compound.
• Do not disassemble the camera.
WARNING
BK0251800US.book 93 ページ ２０１７年５月１８日 木曜日 午後２時４８分