Mitsubishi MOTORS Outlander 2018, Owner'S Manual

Page: 316 / 441

HomeLink® Wireless Control System (if so equipped)
Features and controls 5-235
5
The HomeLink
®
has the capability of listen-
ing to these messages at a range up to 820.2
feet (250 m) (open line of sight), but range
may be reduced by obstacles such as houses
or trees. You may have to slow your vehicle
speed to receive the CLOSED or OPENED
message feedback from the garage door
opener. If the unit is out of range before
receiving either the UP or DOWN message
from the door opener, both the UP and
DOWN indicators will flash red followed by
a continuous lit orange indicator in the direc-
tion the door was last moving.
Recall of the door state after initial feedback
is possible by simultaneously pressing either
HomeLink
®
buttons 1 and 2 or buttons 2 and
3 for 2 seconds. The last recorded message
will be displayed for 3 seconds, again follow-
ing the garage door status indication of the
figure above.
N00585300023
To erase programming from the 3 buttons
(individual buttons cannot be erased but can
be “reprogrammed” as outlined below), fol-
low the steps noted:
1. Press and hold the 2 outer HomeLink
®
buttons for at least 10 seconds. The indi-
cator will change from continuous yellow
to rapidly flashing green.
2. Release both buttons.
3. HomeLink
®
is now in the train (or learn-
ing) mode and can be programmed at any
time beginning with “Programming a new
HomeLink
®
” step 1.
N00585400024
To reprogram a HomeLink
®
button, complete
the following.
1. Press and hold the desired HomeLink
®
button. Do not release the button.
2. The indicator light will begin to slowly
flash orange after 20 seconds. The Home-
Link
®
button can be released at this point.
Proceed with “Programming a new
HomeLink
®
” step 2.
N00585600026
Your HomeLink
®
system operates on a radio
frequency subject to Federal Communica-
tions Commission (FCC) Rules (For vehicles
sold in U.S.A.) and Industry Canada Rules
(For vehicles sold in Canada). This device
complies with Part 15 of the FCC Rules and
RSS- 210 of the Industry Canada Rules.
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
that may be received, including interfer-
ence that may cause undesired operation.
Clearing the programmed
information
NOTE
 Do not hold for longer than 20 seconds.
Reprogramming a single
HomeLink
®
button
NOTE
 If you do not complete the programming of a
new device to the button, it will revert to the
previously stored programming.
For questions or comments, visit
www.homelink.com,
www.youtube.com/HomeLinkGentex, or by
calling the HomeLink
®
Hotline.
General information
BK0249100US.book 235 ページ ２０１７年５月１０日 水曜日 午前８時４９分