Mitsubishi MOTORS Outlander 2018, Owner'S Manual

Page: 62 / 441

Child restraint systems
Seat and restraint systems 4-33
4
2. Route the seat belt through the child
restraint system according to the instruc-
tions provided by the child restraint sys-
tem’s manufacturer. Then insert the seat
belt latch plate into the buckle. Make sure
you hear a “click” when you insert the
latch plate into the buckle.
3. To activate the ALR child restraint instal-
lation function, slowly pull the shoulder
part of the belt all the way out of the
retractor until it stops. Then let the belt
feed back into the retractor.
4. After the belt has retracted, tug on it.
If the belt is in the ALR function, you will
not be able to pull it out. If the webbing
can be pulled out from retractor, the ALR
function has not been activated and you
will need to repeat steps 3 and 4.
5. After confirming that the belt is locked,
grab the shoulder part of the belt near the
buckle and pull up to remove any slack
from the lap part of the belt allowing the
slack to feed into the retractor. Remember,
if the lap belt portion is not tight, the child
restraint system will not be secure. It may
help to put your weight on the child
restraint system and/or push on its seat-
back while pulling up on the belt (See
illustration).
If your child restraint system requires the use
of a tether strap, fasten the tether strap in
accordance with the following procedures.
BK0249100US.book 33 ページ ２０１７年５月１０日 水曜日 午前８時４９分