Mitsubishi MOTORS Outlander 2018, Owner'S Manual

Page: 87 / 441

Electronic immobilizer (Anti-theft starting system)
5-6 Features and controls
5
N00562201149
You can program new keys to the system if
you have two valid (already registered) keys
and blank immobilizer key (specially cut for
your vehicle at your Mitsubishi Motors
dealer) by doing the following:
1. Insert the first valid key into the ignition
switch and turn the key to the “ON” posi-
tion for 5 seconds.
2. Turn the key to the “OFF” or “LOCK”
position and remove the first key.
3. Within 30 seconds of removing the first
key, insert the second valid key into the
ignition and turn it to the “ON” position.
About 10 seconds later, the immobilizer
display will start to blink.
4. When the immobilizer display starts
blinking, turn the second valid key to the
“OFF” or “LOCK” position and remove
it. Within 30 seconds after doing so, insert
a blank immobilizer key into the ignition
switch and turn it to the “ON” position.
Perform this operation no more than 30
seconds after the immobilizer display
starts blinking. When registration of the
ID code is complete, the immobilizer dis-
play will come on for 30 seconds then go
off. If an error occurs, the blinking immo-
bilizer display will go off during the pro-
cedure.
Type 1
Type 2
5. If you wish to register another key, per-
form the process again from step 1.
Customer key programming
(Except for vehicles sold in
Canada) NOTE
 Perform the operation when the interrupt dis-
play screen is not showing. The interrupt dis-
play screen may prevent you from seeing the
immobilizer display.
 It is not possible to register a key if:
• the immobilizer display goes off during the
procedure
• the immobilizer display does not come on
within 30 seconds after step 4.
 The procedure will be terminated automati-
cally if:
• a period of 30 seconds or longer elapses
from the moment when the first key is
turned to the “OFF” or “LOCK” position to
the moment when the second key is turned
to the “ON” position
• a period of 30 seconds or longer elapses
from the moment when the second key is
turned to the “OFF” or “LOCK” position to
the moment when the blank immobilizer
key is turned to the “ON” position
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to “Keyless entry system: Cus-
tomer remote control transmitter program-
ming” on page 5-10.
BK0249100US.book 6 ページ ２０１７年５月１０日 水曜日 午前８時４９分