Mitsubishi MOTORS Outlander 2018, Owner'S Manual

Page: 188 / 441

Adaptive Cruise Control System (ACC) (if so equipped)
Features and controls 5-107
5
N00518901374
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 5-106, you can resume the previously
set speed by push up the RES+ switch (C)
while driving at a speed of about 25 mph (40
km/h) or higher.
The “SET” indicator appears on the informa-
tion display in the meter cluster. (For vehicles
equipped with the color liquid crystal display
meter)
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:

The CRUISE CONTROL ON/OFF
switch is pressed.
 The operation mode is put in OFF.

Indicator goes off.
N00576800048
ACC maintains a set speed with no need for
you to use the accelerator pedal. Using a sen-
sor (A), the system also measures the relative
speed and distance between your vehicle and
a vehicle in front, and maintains a set follow-
ing distance between your vehicle and the
vehicle in front by automatically decelerating
your vehicle if it becomes too close to the
vehicle in front.
The cruising set speed can be set from 25
mph (40 km/h) to 110 mph (180 km/h). The
distance can be selected from three levels.
If the vehicle in front decelerates, the ACC
will automatically apply limited braking to
maintain the distance, and if the front vehicle
then accelerates, the ACC will automatically
accelerate your vehicle up to the set speed. If
your vehicle is approaching too close to the
front vehicle, a buzzer will sound and a warn-
ing is shown in the multi information display.
When the ACC detects no vehicle ahead, the
set speed will be maintained.
Conventional cruise control mode without the
distance control can also be selected.
Stop lights are illuminated during automatic
braking.
To resume the set speed Adaptive Cruise Control
System (ACC)
(if so equipped)
WARNING
 Before using the ACC, read this entire sec-
tion to understand the limitations of this
system. Failure to follow instructions
could result in an accident.
 Never rely solely on the ACC. The ACC is
not a collision avoidance system or an
automatic driving system. It is designed to
use only limited braking and is never a
substitute for your safe and careful driv-
ing. Always be ready to apply the brakes
manually.
BK0249100US.book 107 ページ ２０１７年５月１０日 水曜日 午前８時４９分