Mitsubishi MOTORS Outlander 2018, Owner'S Manual

Page: 302 / 441

Wiper and washer switch
Features and controls 5-221
5
Can only be used when the ignition switch or
the operation mode is in ON.
If the lever is put in the “AUTO” position, the
rain sensor (A) will detect the extent of rain
(or snow, other moisture, dust, etc.) and the
wipers will operate automatically.
Keep the lever in the “OFF” position if the
windshield is dirty and the weather is dry.
Wiper operation under these conditions can
scratch the windshield and damage the wip-
ers.
If your hands get trapped, you could suffer
injuries or the wipers could malfunction. Be
sure to turn the ignition switch to the “OFF”
or “LOCK” position or put the operation
mode in OFF, or move the lever to the “OFF”
position to deactivate the rain sensor.
Rain sensor
CAUTION
 With the ignition switch or the operation
mode in ON and the lever in the “AUTO”
position, the wipers may automatically oper-
ate in the situations described below.
• When cleaning the outside surface of the
windshield, if you touch the rain sensor.
• When cleaning the outside surface of the
windshield, if you wipe with a cloth the rain
sensor.
• When using an automatic car wash.
• A physical shock is applied to the wind-
shield.
• A physical shock is applied to the rain sen-
sor.
NOTE
 To protect the rubber parts of the wipers, this
operation of the wipers does not take place
even if the lever is put in the “AUTO” posi-
tion when the vehicle is stationary and the
ambient temperature is approximately 32 °F
(0 °C) or lower.
 Do not cover the sensor by affixing a sticker
or label to the windshield. Also, do not put
any water-repellent coating on the wind-
shield. The rain sensor would not be able to
detect the extent of rain, and the wipers
might stop working normally.
CAUTION
 In the following cases, the rain sensor may
be malfunctioning. Have the vehicle checked
at an authorized Mitsubishi Motors dealer or
a repair facility of your choice.
• When the wipers operate at a constant inter-
val despite changes in the extent of rain.
• When the wipers do not operate even
though it is raining.
 The wipers may automatically operate when
things such as insects or foreign objects are
affixed to the windshield on top of the rain
sensor or when the windshield is frozen.
Objects affixed to the windshield will stop
the wipers when the wipers cannot remove
them. To operate the wipers again, move the
lever to the “LO” or “HI” position.
Also, the wipers may operate automatically
due to strong direct sunlight or electromag-
netic wave. To stop the wipers, move the
lever to the “OFF” position.
 Contact an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when replacing the windshield glass.
NOTE
BK0249100US.book 221 ページ ２０１７年５月１０日 水曜日 午前８時４９分