Mitsubishi Electric Melservo-H Series, Specifications And Instruction Manual

Page: 17 / 92

1 - 6
1. FUNCTIONS AND CONFIGURATION
1.7 Parts identification
1.7.1 MR-HP-30KA
TE1-1
TE3
Refer To
TE2-1, TE2-2 (PN terminals)
Connect to the servo amplifier using the connection
conductors supplied to the servo amplifier.
Display
The four-digit, seven-segment LED shows the servo
status and alarm number.
Chapter 4
Operation section
Used to perform status display, diagnostic, alarm and
parameter point table operations.
MOVE UP DOWN SET
Used to set data.
Used to change the
display data in each
mode.
Used to change the
mode.
Charge lamp
Lit to indicate that the main circuit is charged. While
this lamp is lit, do not reconnect the cables.
CN1
Outputs an alarm signal.
CN3
For maker adjustment. Leave this open.
CN6
For maker adjustment. Leave this open.
CN5
Connect to CN5A of the servo amplifier.
(Ground terminal)
TE1-2
Supply main circuit power.
Section
3.2.2(1)
TE1-1
Connect the regenerative brake option or DC reactor.
TE3
Supply control circuit power.
Section 3.1.2
TE1-2
TE2-1 TE2-2
Name/Application
Section 3.2.2
Chapter 4
Section 3.2.2
Section 3.2.2
Section 3.2.2