MISA OPTION CloudGate, Technical Documentation Manual

Page: 47 / 218

44 / 215
Option CloudGate - Last updated on 14/05/2014
Enabled
Enables and disables the WWAN (3G) interface,
●
Set to Yes (default) to enable the WWAN interface. If there is no Internet connection available on the
●
Ethernet interface, the device automatically connects to the network using the WWAN interface on
startup.
Set to No to disable the the WWAN interface. The only network connection possible is through the
●
Ethernet interface.
Only upon traffic
By default, the device is always connected to the network and can send and receive data in both
●
directions: Internet to CloudGate, and CloudGate to Internet. To protect the device from
unauthorized access and ensure you only pay for the data you want to send, you can configure the
device to connect only when it has data to transmit.
Set to Yes to connect the device to the WWAN when it has data to send and disconnect it
●
immediately after. Note that when the device is disconnected, it is also unable to receive data.
Option recommends enabling this feature only if you are interested in one way,
CloudGate-to-Internet data flow.
Set to No (default) to disable sending data only upon traffic.
●
IMPORTANT:
IMPORTANT:
Remote login to the CloudGate does not work when
Remote login to the CloudGate does not work when
Only upon traffic
Only upon traffic
is enabled.
is enabled.
Connect while on roaming
Manages international roaming settings for a device installed in a vehicle.
●
If set to Yes, international roaming is enabled.
●
If set to No, internaltional roaming is disabled. Option recommends disabling this feature to prevent
●
high roaming costs.
IMPORTANT:
IMPORTANT:
National roaming is always allowed on the CloudGate. The
National roaming is always allowed on the CloudGate. The
Connect while on
Connect while on
roaming
roaming
feature only has an impact on international roaming behaviour.
feature only has an impact on international roaming behaviour.
WWAN Div Antenna present
Enables antenna diversity.
●
The base unit supports two antenna interfaces: WWAN with Diversity/GPS and WWAN Main. Using
●
both antennas ensures better reception in low coverage areas and increased throughput.
If set to Yes, antenna diversity is enabled and both physical antennas must be installed.
●
If set to No,make sure only one antenna is connected to WWAN Main on the front panel.
●
IMPORTANT:
IMPORTANT:
Installing one antenna with diversity enabled (set to
Installing one antenna with diversity enabled (set to
Yes
Yes
), results in poor or unstable
), results in poor or unstable
performance. Make sure that diversity is disabled when there is only one antenna installed.
performance. Make sure that diversity is disabled when there is only one antenna installed.
Passthrough Mode