MISA OPTION CloudGate, Technical Documentation Manual

Page: 31 / 218

28 / 215
Option CloudGate - Last updated on 14/05/2014
Mounting the CloudGate
The CloudGate can be mounted on a wall or DIN rail.
IMPORTANT:
IMPORTANT:
All mounting hardware is installer provided.
All mounting hardware is installer provided.
Mounting on a wall
The CloudGate can be mounted on a wall with six screws. The mounting holes in the base of the
CloudGate have a diameter of 4.3 mm. Option recommends using screws with a minimum width of 4
mm and a minimum length of 30 mm (M4x30mm).
TIP:
TIP:
When choosing the mounting orientation of the unit, consider the direction of the cables and
When choosing the mounting orientation of the unit, consider the direction of the cables and
antennas. Make sure cables are routed with sufficient ease to all connectors, and that the
antennas. Make sure cables are routed with sufficient ease to all connectors, and that the
antennas are unobstructed for easy positioning. The front panel LEDs should also be visible.
antennas are unobstructed for easy positioning. The front panel LEDs should also be visible.
To wall mount the CloudGate:
Mark the six holes with a pencil on the wall. 1.
Drill (if necessary) the holes in the mounting surface. Do not drill into the CloudGate housing. 2.
Click here for a drawing of the mounting holes.
Mount the CloudGate with six M4x30mm screws 3.
Mounting on a DIN rail
To mount the CloudGate on a DIN rail, use two DIN rail adapters. Option recommends adaptors from
the following companies:
Phoenix Contact
●