Mindray HyBase 8300, Operator'S Manual

Page: 119 / 176

Clamp
7-9
7.5.3.2 Installation and Use
1. As Figure 7-5 shows, slide the clamp housing onto the side rail of the operating table.
2. Insert the accessory into the opening of the clamp.
3. Tighten the locking handle to lock the accessory.
4. Make sure both the clamp and the accessory are reliably installed.
Figure 7-5 Correctly installing the clamp

Make sure the clamp is tightly locked on the side rail and positioned upright.
Otherwise, the accessory can fall and cause personal injury and/or property
damage.

Make sure the locking handle is properly tightened. Otherwise, the
accessory can fall and cause personal injury and/or property damage.

Be sure to correctly install the clamp, as Figure 7-5 shows. Otherwise, it can
fall and cause personal injury and/or property damage.

Before removing the accessory, be sure to hold the clamp. Otherwise, it can
fall and cause personal injury and/or property damage.
Upward