MIMAKI JV5-320S, Operation Manual

Page: 70 / 312

2 Before Use
2-34
MACHINE SET functions
Function name Sub function Setting value Function
Feeding / TakeUP
(p. 6-20)
FEEDING ON, OFF Set whether to use or not to use
heavy-duty feeding / take-up device.
TAKE-UP ON, OFF
DRYNESS FEED
(p. 6-20)
ON, OFF Change the feed operation after
printing.
CONFIRM. FEED
(p. 6-20)
ON
Press [FUNC-
TION] key to set
items on the right.
BACK FEED ON, OFF Set whether or not to perform feed-
ing the media after test printing for
checking of the printing result.
OFF
PRE-FEED
METHOD
(p. 6-20)
[Only when dedi-
cated sublimation
transfer ink is used.]
FORE (**mm)
Press [FUNC-
TION] key to set
items on the right.
LENGTH 10mm to 1000mm Switches the pre-feed operation.
FORE&BACK
HEATER SETUP (p. 6-20) STD, set -5°C, set -10°C, set -15°C,
set -20°C Change the temperature range of the
post-heater that determines whether
the temperature is reached.
MEDIA CUT
(p. 6-21)
ASSIGN CUT KEY ON, OFF Allocate [>] key to DIRECT CUT
key of MEDIA CUT.
MOVE.DROP MEDIA ON, OFF Switch the dropping operation of the
media after cutting media.
TIME SET (p. 6-21) ON, OFF Set the date and time on the printer.
UNIT SETUP
(p. 6-21)
TEMP. °C or °F Change the units of temperature,
length and area to be used with the
printer.
LENGTH mm or inch
STAMP SETUP (p. 6-22) ON, OFF Make settings for outputting the date
and time and printing conditions
after printing.
CART.PRIORITY (p. 3-74) INK LEVEL, EXP. DATE Set the cartridge status to use first in
the double cartridge automatic
switching function.
Test Draw Arrange (p. 6-23) FEED Dir, SCAN Dir. Set the arrange direction of the test
pattern to be drawn when perform-
ing test drawing repeatedly.
MEDIA DETECT
(p. 6-23)
ThicknessDETECT AUTO, MANUAL Set how to detect media thickness
performed prior to the detection of
media width.
FEED ERR. DETECT ON, OFF Set how to detect the end of media
when using roll media.
MACHINE NAME (p. 6-23) 01 to 99 When the printer is connected
through the USB 2.0 interface to a
system to which two or more
machines are connected, set the
identifier of the printer to have the
system recognize it.
ENV. TEMP. (p. 3-70) Not wait ARR., Wait arrival Set the operation when drawing was
tried to start with the temperature of
the place where this machine has
been installed being outside the
range of usable temperature.