MIMAKI JV5-320S, Operation Manual

Page: 233 / 312

5-25
Troubles for which error messages are displayed
∗∗∗∗
ERROR 163
∗∗∗∗
NCU SENSOR DETECT
An error occurred in the control sys-
tem. Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
Operation can be resumed after turning
off the nozzle missing detection func-
tion.
∗∗∗∗
ERROR 164
∗∗∗∗
NCU FPGA ERROR
An error occurred in the control sys-
tem.
∗∗∗∗ ERROR 200 ∗∗∗∗
HEAD MEMORY (----)
An error occurred in the circuit board
system. Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
∗∗∗∗
ERROR 201
∗∗∗∗
BACKUP MEMORY
An error occurred in the circuit board
system.
∗∗∗∗
ERROR 201
∗∗∗∗
BACKUP DATA
An error occurred in back-up data. The continued use is possible.
If the error message appears fre-
quently, please call for services.
∗∗∗∗ ERROR 202 ∗∗∗∗
DEVICE CONSTRUCTION
An error occurred in the control sys-
tem. Contact your local distributor to call
for service.
Press the [ENTER] key to display the
details of the error. Press the [ENTER]
key again to enable the system to be
started after changing the configura-
tion to a supported one.
(See 5-13)
∗∗∗∗
ERROR203
∗∗∗∗
SDRAM SIZE
An error occurred in the control sys-
tem. Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
(When there is available SDRAM
mounted, the printer operation can be
resumed without expanding SDRAM.
However, printing speed may drop
depending on the resolution.)
∗∗∗∗ ERROR 207 ∗∗∗∗
SLEW RATE (----)
An error occurred in the wave shape
control during printing. Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
∗∗∗∗
ERROR 207
∗∗∗∗
OVERFLOW (----)
∗∗∗∗
ERROR 207
∗∗∗∗
UNDERFLOW (----)
∗∗∗∗
ERROR 207
∗∗∗∗
COM ABN. (----)
∗∗∗∗
ERROR 210
∗∗∗∗
INTERLOCK SENSOR
An error occurred in the control sys-
tem. Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
Error message Cause Remedy