MIMAKI JV5-320S, Operation Manual

Page: 39 / 312

2-3
Configurations and Functions
Name Function
1 Ink station Set the specified ink cartridges in the ink station.
2 Ink cartridges Each cartridge contains an ink of a particular color.
3 Cartridge LEDs The LEDs (green and red) in each slot indicate the cartridge status.
4 Maintenance cover L
Open the maintenance cover L and/or maintenance cover R when doing so is
required for maintenance. Even when the power switch is off, keep all covers
closed.
5 Platen
The printed media is sent out, sliding on the platen. Three heaters are installed
inside the platen.
6 Post-heater Dries the ink on the printed media.
7 Carriage Moves the print head unit from side to side.
8 Print heater
Fixes and dries the ink on the currently produced print. (Located inside the
platen)
9 Front cover
Open this cover when media is to be set or the jammed media is to be removed.
Even when the power switch is off, keep this cover and the other covers closed.
10 Power switch
Turns on/off the power to the printer.
While the main power switch is on, the operation to prevent ink clogging is per-
formed periodically even when the power switch is off. (Flushing function)
11 Operation panel
This panel has the operation keys required for operating the printer and the
LCDs for displaying setting items, etc.
It is also provided with the power switch for the heaters and the LEDs for indi-
cating the heater status.
12 Maintenance cover R
Open the maintenance cover R and/or maintenance cover L when doing so is
required for maintenance. Even when the power switch is off, keep all covers
closed.
13 Capping station Incorporates the ink caps, with which the heads are covered, and the wiper, etc.
14 USB 2.0 connector USB 2.0 interface.
15 AC inlet Connect the power cable to the AC inlet.
16 Main power switch
Turns on/off the main power for the printer. Leave the main power turned on to
prevent ink clogging.
Turn off the power switch in front, before turning off the main power switch.
17 Waste ink tank Waste ink gathers in this tank.
18 Take-up device Automatically winds up the roll media printed (1600 mm wide or less).
19 Clamp lever (Front) Moves the pinch rollers up and down to hold or release the media.
20 Heavy-duty take-up device Automatically winds up the heavy-duty roll media printed.
21 Media shaft (Front) Holds heavy-duty media.
22 Tension bar (Front) Adjusts the tension of heavy-duty roll media.
23 Media set label
A scale to set media in the center of the printer. (This is under Pre-heater on the
rear of the printer)