MIMAKI JV5-320S, Operation Manual

Page: 125 / 312

3-53
If dots are not in alignment [DROP.POScorrect]
5
Press the [

] or [

] key to correct the dot position of pattern 1.
Select the correct dot position on [PATTERN 1] using the JOG key [

] or [

].
Select the dot position where the dots of outward trip and those of homeward trip form a straight line on the test
pattern.
6
Press the [ENTER] key.
7
Subsequently repeat Steps 5 and 6 three times to correct the dot positions on Pattern
2 to Pattern 4.
Select the correct dot position on each of the patterns.
Enter the dot position correction values on Patterns 1 to 4 and then terminate dot position correction.
8
Press the [END] key several times.
The printer returns to LOCAL mode.

If no correction value for straight line pattern is found within the range from -40
to +40, adjust the head height and then execute the [DROP.POScorrect] func-
tion again.
Input COMP value.
-40.0 - +40.0
DROP.POScorrect
PATTERN1
= 0.0
Input range:
Patterns 1 to 4
-40.0 to 40.0
Output direction
The dots at the fourth position counted
from the zero position in the positive
direction form a straight line.
In this case, the dot position correction
value is 4.0.
Input COMP value.
-40.0 - +40.0
DROP.POScorrect
PATTERN2
= 0.0
Input range:
Patterns 1 to 4
-40.0 to 40.0
L. ∗ > [JV5-01]
width :
∗∗∗∗
mm