MIMAKI JV5-320S, Operation Manual

Page: 127 / 312

3-55
Establishing the Origin
Establishing the Origin
Establish the origin for printing the data on the media loaded on the printer.
When printing requires an area other than that defined by the established origin, set the origin at another point
by following the origin setting procedure again.
STEPS:
1
Once the media detection is completed, move the carriage and media using the JOG
keys [

], [

], [

] and [

] so that the carriage is located at the position where the
origin is to be established.
2
After determining the origin, press the [ENTER] key.
The printer displays the effective printing area, and then returns to LOCAL mode. (When the roll media is used,
the value in X direction is not displayed.)
From the time the printer starts next printing, it uses the origin that has been established here unless the origin
is newly established at another point.

When moving the origin to the back of the media, switch the moving direction
as follows.
Origin
(Length)
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
ORIGIN SET UP
0.0 −−−−
Origin
(Width)
FEED DIRECTION SET
[ FORE FEED ]
ORIGIN SET UP : FORE
0.0
−−−−
ORIGIN SET UP : BACK
0.0 −−−−
FEED DIRECTION SET
[ BACK FEED ]
(Switch the direction) (Move by the same direction key)
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
ORIGIN SET UP
0.0
−−−−
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
ORIGIN SET UP
∗ ∗ ORIGIN ∗ ∗