MIMAKI DS-1600, Operation Manual

Page: 35 / 172

- 1.17 -
Changing gap for fablic retainers
• When the thickness of the fabric used is 0 to 4mm, use it with the stainless plate
adjusted by moving the outside long hole hole and then secured with a screw.
• When the thickness of the fabric used is 3 to 7mm, use it with the stainless plate
adjusted by moving the inside long hole hole and then secured with a screw.
• When raising the stainless plate, be sure to adjust the head height. Failure to
do so may cause damage to the head.
Installing IEEE1394 output driver
When connecting the plotter using the host computer and IEEE1394 interface, it may be
necessary to install the IEEE1394 output driver and RasterLink Pro (RIP).
Installing USB output driver
When connecting the plotter using a USB interface, it is necessary to install theUSB2.0 out-
put driver and RasterLink Pro (RIP).
• For the installation procedure, refer to the contents of the CD-ROM supplied
with the plotter.
• RasterLink Pro is optional accessory.
• USB2.0 interface board is available as option. Installation is a service engi-
neer work. Be sure to call a service engineer.