MIMAKI DS-1600, Operation Manual

Page: 75 / 172

- 2.9 -
Correcting the media feed rate during printing [Feed Comp.]
Even for fabric of the same type, if the thread size or texture is slightly different, the proper
value of the feeding amount changes.
In this case, correct the feeding amount of the fabric while checking the printing condition.
• To change the fabric type or print data, be sure to perform [Feed Comp.].
• During [Feed Comp.] printing, does not print correction patterns. Perform
only correction value input operation while checking print data.
STEPS:
1. Press the [FUNCTION] key on REMOTE mode.
The current setting value can be confirmed.
Press the [END] key when an appropriate value is set or to
abort the operation.
2. Press the [ENTER] key.
Available to alter the fabric feed rate.
3. Press the JOG key [ ] or [ ] as needed to set
the amount of correction.
Setting value is available from -500 to +500. Press [END] key
to return to the REMOTE display. The altered value ceases to
be in effect, and returns to the previous value.
• A new value takes effect in real time. The best effect can be obtained while
checking the result.
• Make judgment from the result obtained after 4 scans (for 4-pass printing) or
8 scans (for 8-pass printing).
• The unit of the correction value is the same as in “Media Comp.” in the LO-
CAL mode.
• Setting value is to be Reset as follow,
*Perform the “MEDIA COMP.” .
*Perform the “SETUP RESET”
4. Press the [ENTER] key.
Confirm the fabric feed rate before saving it.
< R E M O T E >
T Y P E 1
0 . 0 m
F E E D C O M P . - 2 0 0
A D J U S T : e n t
F E E D C O M P . - 2 0 0
A D J U S T = 1 0 0
F E E D C O M P . - 2 0 0
A D J U S T = 1 0 0
F E E D C O M P . - 1 0 0
S A V E : e n t