MIMAKI DS-1600, Operation Manual

Page: 62 / 172

- 1.44 -
Removing pinch roller and preventing wrinkle of fablic
If either edge of the fabric stretches longer than the center or if an edge of the fabric is
thickened because of gumming processing to prevent fray, slack may occur easily. In this
case, remove the pinch rollers at both ends of the fabric.
STEPS:
1. Move up the clamp lever on the front face.
The pinch roller comes up.
2. Loosen the hand screws on both sides of the
pinch roller to be removed.
3. Pull out the pinch roller.
4. To prevent fall-off or loss of the hand screws,
lightly fasten them.
• If the lengths of the fabrics at the left and right
pinch rollers removed are different remarkably,
reset the fabric. (Perform the operation of
"SETTING THE ROLL", from step5. on page
1.35 to page 1.43 again.)