MIMAKI DS-1600, Operation Manual

Page: 66 / 172

- 1.48 -
Origin setting
Establish an origin in terms of data on fabric loaded on the plotter. Place the fabric and cause
the plotter to detect the fabric, the origin is automatically established at the location shown in
the illustration given below.
Horizontal direction : Position 10mm apart from
the left edge of the fabric retainer
Setting of an origin
If you want to perform printing at another location of a roll fabric that provides a wider printing
area, it is necessary to re-establish another origin.(See page 3.15)
STEPS:
1. After the fabric detection is completed, press the
JOG keys [ ], [ ], [ ], and [ ] to move the car-
riage to the position at which to set an origin.
As the carriage is moved, the origin shifts in position. The ori-
gin that changes with the movement of the carriage is displayed
on the LCD.
2. After deciding the origin, press the [ENTER] key.
The origin has been changed.
10 mm
Roll fabric
Fabric Retainer
Origin
O R I G I N S E T U P
0 . 0 0 . 0
O R I G I N S E T U P
* * OR I G I N * *
< < L O C A L > >
w i d t h : 1 2 7 2 m m
Origin(Length)
Origin (width)