Miller AG-BAG Professional LX1214, Operator'S Manual

Page: 43 / 158

37
Two Wheel Drive/Four Wheel Drive Switch
Four Wheel Drive
Two Wheel Drive/Four Wheel Drive
Switch
The two wheel drive/four wheel drive is a two
position rocker switch located on the right side
corner post.
Push the top of the switch in for two wheel drive.
In this position only the engine end wheels will
drive. Two wheel drive is used in the transport
drive mode only and allows the bagger to travel
at a higher ground speed than four wheel drive.
When in two wheel drive, ONLY drive on smooth
level surfaces and Do Not make sharp turns.
Push the bottom of the switch in for four wheel
drive. In this position all four wheels will be
driving. Use this position for bagging mode and
trailer mode for driving on to and off of a trailer.
Two Wheel Drive
Drive/Align Switch
The drive/align switch is a two position rocker
switch located on the right side corner post.
When switching drive modes, the wheels may
need some realignment to complete the mode
change. In this case press the top of the switch
and then realign the wheels as called for on the
display panel. Wheel drives will not function with
switch set to align.
Push the bottom of the switch in after alignment
is complete to drive the unit.
Drive/Align Switch
Press to Drive
Press to Align