Miller AG-BAG Professional LX1214, Operator'S Manual

Page: 151 / 158

145
Tire Air Pressure
It is recommended that the tire manufacturer’s
tire pressure as indicated on the side wall of the
tire be maintained. Check the tire pressure daily.
Wheel Lug Nut Torque
Check the wheel lug nut torque weekly. Torque
the lug nuts to 270 ft.-lbs (366 Nm).
Retorque the wheel lug nuts each time a wheel
is removed. Then retorque the lug nuts after one
hour of use.
Tine Cap Replacement
As the tine caps wear they can be replaced.
The tine caps on your bagger are welded to the
rotor teeth. To remove the tine cap, grind the
weld away at the tip of the cap.
Unhook the cap from the lower part of the tooth
and remove.
The new tine cap can be welded in place or at-
tached with roll pins.
If the caps are to be attached with the roll pins,
you will need a 3/16” roll pin and a 5/16” roll pin
for each cap.
IMPORTANT: If using the roll pins to assem-
ble the tine cap, be sure the pins are flush on
both sides of the cap.
Tine Caps Welded In Place
Weld Inside Cap
Hook Over This End
Tine caps are available by ordering part number
42.0901179.
3/16” roll pins are available by ordering part
number 902790.
5/16” roll pins are available by ordering part
number 907707.