Miller AG-BAG Professional LX1214, Operator'S Manual

Page: 31 / 158

25
Tunnel Clean Out Switch
Location (I)
The tunnel clean out switch is a three position
(momentary) switch which must be held in posi-
tion. When the switch is released, it will return to
the center (off) position.
IMPORTANT: Always turn the rotor off before
activating the tunnel cleanout. Do not turn
the rotor on unless the tunnel clean out is
completely closed.
Push and hold the top of the switch in to open
(push away from rotor) the tunnel clean out.
When the tunnel clean out is open a icon will
appear on the display panel on the right side
corner post alerting the operator that the clean
out is open. The icon will be displayed until the
cleanout is closed.
Push and hold the bottom of the switch in to
close (bring it toward the rotor) the tunnel clean
out. Once the tunnel clean out is completely
closed, the icon on the display will disappear.
Do not turn the rotor on unless the icon has
disappeared.
Tunnel Clean Out Switch
Tunnel Clean Out Switch
Feed Table Lift/Lower Switch
Location (J)
The feed table lift/lower switch is a three position
(momentary) switch which must be held in posi-
tion. When the switch is released, it will return to
the center (off) position.
Push and hold the top of the switch in to lift the
feed table up.
Push and hold the bottom of the switch in to
lower the feed table down.
Be sure to release the feed table transport lock
located on the cab side of feed table before
lowering the feed table. The feed table lock pin
should remain in the unlocked position while
bagging.
Be sure the feed table sides are in the folded
(down) position before attempting to raise the
feed table.
IMPORTANT: To prevent contact between the
feed table sides and the hopper, feed table
sides must be folded completely down and
against the belt before raising the feed table.
Feed Table Lift/Lower Switch
Feed Table Lift/Lower Switch
Feed Table Transport Lock
Feed Table Transport Lock
Tunnel Clean Out Open Icon on Display