Microtech Xstreamjet, Manual

Page: 22 / 45

- 16 -
Microtech Systems
Insert the screw heads into the holes. 3.
Slide the plate forward until the rear pins on the plate drop into the top of the 4.
drive enclosure.
Note : the four screws on the top of the mounting plate are used to adjust the
printer’s position during the calibration procedure.
Lower the printer onto the plate aligning the pins in the plate to the holes in the 5.
bottom of the printer. Slide the printer onto the pins so that it sits flat on the
plate.
Proceed to the section 6.
Cabling the Xstreamjet
below.
X100 Installation
Follow the steps below to install an Xstreamjet printer onto an X100 system from
Microtech Systems.
Unpack the mounting plate. 1.
Place the mounting plate onto the top of the X100 system. 2.
Start the two screws that attach the plate to the system. Leave the screws loose 3.
enough to allow for sliding the printer during the calibration procedure.
Lower the printer onto the plate aligning the pins in the plate to the holes in the 4.
bottom of the printer. Slide the printer onto the pins so that it sits flat on the
plate.
Figure 13
Final mounting position
Figure 14
X100 mounting plate