Microtech Xstreamjet, Manual

Page: 20 / 45

- 14 -
Microtech Systems
Xpress XE •
Xpress XL •
Xpress XP •
X100 •
The same procedure is used to install the Xstreamjet to an Xpress XE and Xpress XP.
See the section Xpress XE / XP Installation below.
The procedure to install the Xstreamjet to an Xpress XL is described in the section
Xpress XL Installation
below.
The procedure to install the Xstreamjet to an X100 is described in the section X100
Installation below.
Note : using the Xstreamjet with any other system requires prior consultation with, and
approval by, Microtech Systems. Failure to gain approval violates the product license
and voids its warranty.
Xpress XE / XP Installation
Follow the steps below to install an Xstreamjet printer onto either an Xpress XE or
Xpress XP system from Microtech Systems.
Unpack the mounting plate. Locate the included thumbscrews used for 1.
mounting.
Place the mounting plate onto the top of the Xpress system. 2.
Slide the “tabs” on the mounting plate into the slots on the top of the drive 3.
enclosure.
Line up the holes in the mounting plate with the threaded holes on the top of the 4.
drive enclosure.
Screw the thumb screws (provided) into the holes and tighten them a few turns. 5.
Leave the thumb screws loose enough to allow for sliding the printer side to side
during the calibration process.
Figure 9
XE /XP mounting plate