94 Operator Maintenance
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator‘s Manual SOLID T4 / T5 / T6 / T8
Edition 2.0
7.2.1. Printhead Removal and Installation
1. Open the hood of the printer.
2. Switch off the printer and pull the power plug.
3. Remove the ribbon (see chapter 4.3.3).
4. Remove the printmedia (see chapter 4.2.2).
Please pay attention to the following:
- Wait at least 3 minutes after switching off the device
before disassembling the printhead.
- The printhead can be damaged by electrostatic charges.
Therefore first of all touch a properly grounded part of
the printer (f.e. the base plate of the printer).
- The printhead may not be touched on the print bar or
on the plug-in contacts.
- If the printhead is axially adjusted please mark the actual
position at first.
5. Unscrew the two thumb screws on the printhead mounting
until the entire printhead mounting can be removed from the
contact shaft.
Summary of Contents for LOGIJET T4
Page 108: ......
