20 Handling of Consumables
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX
Operator’s Manual SOLID T4 / T5 / T6 / T8
Edition 2.0
4. Handling of Consumables
For thermal direct printing it is not allowed to load a ribbon to
avoid damaging the printhead. Make sure your settings using
the control panel and display respectively via interface (see
chapter 5 and 6) fit to the printer implementation (ribbon
inserted /not inserted).
4.1. Winding Diagram
The diagram above shows the usual winding directions of material and ribbon.
Always follow this diagram when inserting/changing material and ribbon.
Also pay attention to the instructions located on the inside of the device hood.
Ribbon and material should only be inserted/changed by specially instructed
personnel.
Designation of the parts
1 Setting screw, printhead contact
2 Setting — thin/narrow material
3 Setting — medium material
4 Setting — thick/wide material
5 Ribbon transport roller
6 Ribbon roll-up mandrel (ribbon mandrel left)
7 Setting — roll-up speed
8 Setting — unwind speed
9 Ribbon unwinder with ribbon
10 Material unwinder with material
11 Outer guide disc
12 Ribbon
13 Head mounting
14 Printhead (thermal bar)
15 Print roller
16 Sensor setting gap detection
17 Feed roller
18 Pressure rollers
19 Ribbon guide mandrel
20 Fan lever for contact rollers
21 Material end photoelectric switch
22 Material guide
23 Material thickness
24 Material
25 Bouncer arm (not with SOLID T4)
Summary of Contents for LOGIJET T4
Page 108: ......
