Metz Cosmo Series, Operating Instructions Manual

Page: 279 / 399

11
Switching on from stand-by mode
Use the numeric keys of the remote control to select any program.
Program position 1 is selected with the key
or if programmed, there is a switch to the
initial program position, see Chapter 21.1.
Switching off with the remote control
Press the remote control key .
The TV switches to stand-by mode and the LED display lights up.
When the LED display turns yellow or blue-red, the TV is in the process of collecting data for
electronic program listings.
Switching off with the power switch
If the red LED display is illuminated or “EPG” appears in the display, the TV set is still
gathering data for the electronic program guide.
5 The remote control
The remote control conveys commands to the TV set via infrared light. The remote control
must always be directed at the TV set. Other infrared controlled devices or systems
(e.g. infrared headphones) within its range could be destroyed.
Direct sunlight on the TV set may lead to disruptions, because the TV set is unable to
recognise the infrared signals of the remote control. To enable the TV set to be controlled by
the remote control, it cannot be switched off with the power switch.
No rechargeable batteries may be inserted in the battery compartment of the
remote control!
Only two LR03/AM4/AAA 1.5 V micro batteries may be used.
The batteries that are used must not be exposed to excessive heat such as sunshine,
fire or the like!
On / Off
Program
selection