MI 2792 PowerQ4 Plus
Recording Practice and Instrument Connection
97
When the time zone is set, PowerQ4 Plus will synchronize its system time clock and
internal RTC clock with the received UTC time. GPS module also provides the
instrument with extremely accurate synchronization pulses every second (PPS – Pulse
Per Second) for synchronization purposes in case of lost satellite reception.
Note:
GPS synchronization should be done before starting measurements.
For detailed information please check user manual of A 1355 GPS Receiver.
4.2.6 GPRS modem connection
PowerQ4 Plus can be remotely controlled through GPRS modem (optional accessory -
A 1356). In order to establish remote connection with instrument through PC software
PowerView v2.0, communication parameters should be configured. Figure bellow show
COMMUNICATION menu in GENERAL SETUP.
Figure 4.19: GPRS connection setup screen
Following parameters should be entered in order to establish GPRS communication:
Table 4.4: GPRS setup parameters
Number: Required
Enter phone number
PIN: Optional
Enter this parameter if it if your SIM card request. If you
don’t disable PIN code on your SIM card, put SIM Card
into you mobile phone and disable it.
Secret key
Required
Enter number code (for example 3-digits). User need to
store this number, as will be later asked by PowerView
v2.0, during connection procedure
APN Required
Username Required
Password Required
Those parameters are provided by your local mobile
provider, from whom SIM card for GPRS modem was
bought. They are required by GPRS modem in order to
establish internet connection.
After entering parameters user should connect PowerQ4 Plus and modem with attached
cable and activate initialization (
INIT
) by pressing on function key
. New window will
appear on screen and GPRS test will start.
