Comply with the country-specific regulations for
using the rear fog lamp.
▌
Adjusting headlamp range
#
Turn headlamp range adjuster
1
to the
required position.
#
If the vehicle is unladen, select position
g
.
The illumination of the road should be 40 m to
100 m and the low beam must not dazzle oncom-
ing traffic.
You can use the headlamp range adjuster to adjust
the light cone of the headlamps to your vehicle's
load condition. As the seats are occupied or the
load compartment is loaded or unloaded, the light
cone changes. This may cause visibility conditions
to deteriorate and you could dazzle oncoming traf-
fic.
Operating the combination light switch
1
High beam
2
Right turn signal light
3
Headlamp flashing
4
Left turn signal light
#
Use the combination switch to select the
desired function.
Switching on high beam
#
Switch on the low beam (
/
page 104).
#
Push the combination switch forwards
1
.
The
K
indicator lamp on the instrument
cluster will light up.
%
In the
Ã
position, the high beam switches
on only in darkness and when the vehicle is
switched on.
Headlamp flashing
#
Briefly pull the combination switch in the direc-
tion of arrow
3
.
Turn signal light
#
To indicate: push the combination switch in the
required direction
2
or
4
until it engages. In
the case of larger steering movements, the
combination switch will reset itself automati-
cally.
#
To indicate briefly: tap the combination switch
briefly in the required direction
2
or
4
. The
corresponding turn signal lamp will flash three
times.
Switching the hazard warning light system on/off
#
Press button
1
.
If you operate a turn signal indicator while the haz-
ard warning light system is switched on, only the
turn signal lamps on the relevant side of the vehi-
cle will light up.
Light and vision 105
T447 0414 02
Summary of Contents for EQV 2021
Page 1: ...EQV Owner s Manual T447 0414 02 ...
Page 7: ...T447 0414 02 ...
