- 51 -
6-35.INT MASK Command
COMMAND………
F8
Function : Masks detection of each COMPARATOR at its output.
H
Execution sequence
INT MASK is set on the DRIVE DATA3 PORT.
DATA3 PORT
WRITE
Contents of the DRIVE DATA3 PORT is as follows.
COMMAND F8
DATA3 PORT
H
7
0
WRITE
D
D
PLS COMP1 INT MASK
PLS COMP2 INT MASK
Note: D
bit must be set to 0.
PLS COMP3 INT MASK
7
PLS COMP4 INT MASK
PLS COMP5 INT MASK
DFL COMP1 INT MASK
DFL COMP2 INT MASK
Detail of the each bit on the DRIVE DATA3 PORT is as follows.
At POWER ON/RESET, the underlined side is selected.
(1) PLS COMP1 INT MASK (D )
0
This bit is used for enabling or disabling masking of output of the detection from the PULSE COUNTER
COMPARATOR1.
0: Not masked.
1: Masked.
(2) PLS COMP2 INT MASK (D )
1
This bit is used for enabling or disabling masking of output of the detection from the PULSE COUNTER
COMPARATOR2.
0: Not masked.
1: Masked.
(3) PLS COMP3 INT MASK (D )
2
This bit is used for enabling or disabling masking of output of the detection from the PULSE COUNTER
COMPARATOR3.
0: Not masked.
1: Masked.
(4) PLS COMP4 INT MASK (D )
3
This bit is used for enabling or disabling masking of output of the detection from the PULSE COUNTER
COMPARATOR4.
0: Not masked.
1: Masked.
(5) PLS COMP5 INT MASK (D )
4
This bit is used for enabling or disabling masking of output of the detection from the PULSE COUNTER
COMPARATOR5.
0: Not masked.
1: Masked.
(6) DFL COMP1 INT MASK (D )
5
This bit is used for enabling or disabling masking of output of the detection from the DIFFERENTIAL
COUNTER COMPARATOR1. (excessive deviation).
0: Not masked.
1: Masked.
(7) DFL COMP2 INT MASK (D )
6
This bit is used for enabling or disabling masking of output of the detection from the DIFFERENTIAL
COUNTER COMPARATOR2. (in position)
0: Not masked.
1: Masked.
Note1: Even if "Masking" is specified, the COMPARATOR match stop function is not affected.
For details, refer to 8-5.
Note2: BUSY=0 may not be checked.
But, you must not use this command when another command is being
written or written after(less than 4 μS) to the DATA3 PORT to rewrite it.
Summary of Contents for C-875
Page 98: ... 98 2 M TYPE 3 H TYPE ...