![background image](http://html1.mh-extra.com/html/melec/al-ii-series/al-ii-series_instruction-manual_1767041009.webp)
- 9 -
2C-776Av1
Instructions Manual
R1
1-5. Externals of product
J1, J2
These are shield connector of the RJ-45 type that connects the AL-
communication.
Ⅱ
J1 and J2 are connected with each unit and the communications cable can be connected in
the multidrop.
J3
This is a connector to c24 V power supply.
J4
This is a connector to connect an Extend I/O unit Option .
(
)
J5
This is a connector that connects immediate stop FSSTOP signals
and general-purpose I/O
(
)
IN0, IN1, OUT0, and OUT1 signals .
(
)
J6, J7, J8, J9
These are general purpose connector of MIL26 pin for the interface to the driver.
J6 is the one for the X-axis, J7 is one for the Y-axis, J8 is one for the Z-axis,
and J9 is the one for the A-axis.
J10, J11, J12, J13
These are connector to connect the sensor signals such as the LIMIT signal or the ORG signal.
J10 is the one for the X-axis, J11 is one for the Y-axis, J12 is one for the Z-axis,
and J13 is the one for the A-axis.
J14
This is a connector to SIGNAL I/O.
It is a connector where the external equipment and the interface can be done by open collector
output or line driver output signal.
An arbitrary status signal of X axis or Y axis default value = CNTINT
can be output.
(
)
(J13)
(J12)
(J10)
(J11)
ADDRE
SS
(J1)
(J2)
(J3)
(J5)
1
1
(J4)
RATE
(J14)
J10 J11
J9
J8
DC+24V
J3
J5
J4
J1
J2
J6
J7
J12 J13
J14
MADE IN JAPAN