![background image](http://html1.mh-extra.com/html/melec/al-ii-series/al-ii-series_instruction-manual_1767041010.webp)
- 10 -
2C-776Av1
Instructions Manual
S1
This is a setting switch of the slave address of the AL-
communication.
Ⅱ
S2
This is a setting switch of the baud rate of the AL-
communication.
Ⅱ
LED RDY
RDY LED Green color
turns on at the time of RDY state of each axis.
(
)
(
)
Terminal
The terminal connect to the shield when the driver cable of shield.
Use the screw of attached M3
4.
×
Terminal
The terminal connect to the shield when the sensor cable of shield.
Use the screw of attached M2 .6
4.
×
Terminal
The terminal connect to the shield when the SIGNAL I/O cable of shield.
Use the screw of attached M3
4.
×
(
)
Base installation
These are part that fixes the main unit to the installation base. two places
part
Use the M3 screw.
Moreover, it is possible to install it in the DIN rail with a exclusive use DIN attachment lug.
Please refer to the connection/other manual for details.
Cable clamping
Fix the cable clamping accessory
into this hole when you connect the cable for SIGNAL I/O
(
)
installation hole
connector J14 .
(
)
Connector for
This is a connector for adjustment of the main unit.
adjustment
Do not connect anything.