ME-Messysteme GSV-2AS, User Manual

Page: 18 / 66

Table of commands
Note: the command number must be sent as Byte to GSV-2, followed by parameter-bytes.
( the command consist of 1 byte, followed by parameter-bytes).
Command
No.
Command
No.
(Hexadecimal)
Command name Number of
parameters
Number of data
bytes send by the
GSV
0 0 reset status 0 0
1 1 read scale 0 3
2 2 read zero 0 3
3 3 read control 0 3
4 4 read offset 0 2
5 5 write scale 3 0
6 6 write zero 3 0
7 7 write control 3 0
8 8 write offset 2 0
9 9 get all 1 0
10 A save all 1 0
11 B set cal 0 0
12 C set zero 0 0
13 D set scale 0 0
14 E set offset 0 0
15 F set unit 1 0
16 10 set norm 3 0
17 11 set dpoint 1 0
18 12 set frequency 2 0
19 13 set gain 1 0
20 14 set bipolar 0 0
21 15 set unipolar 0 0
22 16 Read frequency
0 3
23 17 Manufacturer setting
24 18 Manufacturer setting
25 19 Manufacturer setting
26 1A get norm 0 3
27 1B get unit 0 1
28 1C get dpoint 0 1
29 1D switch 1 0
30 1E Manufacturer setting
31 1F get serial number 0 8
32 20 set threshold1 4 0
33 21 get threshold1 0 4
34 22 set channel 1 0
35 23 stop transmission 0 0
36 24 start transmission 0 0
37 25 clear buffer 0 0
38 26 set mode 1 0
39 27 get mode 0 1
40 28 Manufacturer setting
41 29 get equipment 0 1
42 2A Manufacturer setting
43 2B firmware version 0 2
44 2C set gauge factor 2 0
45 2D get gauge factor 0 2
46 2E set poisson 1 0
47 2F get poisson 0 1
48 30 set bridge type 1 0
49 31 get bridge type 0 1
50 32 Set Range 1 0
ME-Meßsysteme GmbH, Neuendorfstr. 18a, D-16761 Hennigsdorf
18
Phone 03302 78620 60, Fax 03302 78620 69, info@me-systeme.de , www.me-systeme.de/en