MCCORMICK X60 Series, Operator'S Manual

Page: 52 / 262

52
Controls - Cab
Rotating Beacon
(if equipped).
- The rotating amber beacon must be used according to
local road traffic laws.
The rotating amber beacon is operated by pressing the
switch (2) with the flashing beacon symbol.
Slow Moving Vehicle (SMV) Symbol
(if equipped).
- For correct use of the SMV symbol (3), observe local
road traffic laws.
If a Slow Moving Vehicle (SMV) symbol is equipped it must
be installed on the rear part of the tractor.
To install the SMV symbol on an implement or trailer a
special bracket must be obtained from your dealer.
1
WARNING: Collision of high speed road traf-
fic and tractors or implements can cause
personal injury or death. On roads, use
amber warning lamps according to local
laws. Keep SMV emblem visible. Pull over to
let faster traffic pass. Slow down and signal
before turning off.
Tractor Warning Lamp Usage - Rest
Of World Tractors
-
The flashing amber warning lamps must be used ac-
cording to road traffic laws.
The amber warning lamps are used to indicate a hazard
to other road users. To operate, press the switch (1) as
shown above. ALL the amber warning lamps will flash
ON and OFF.
IMPORTANT: When operating the tractor, towing an
implement or trailer, the complete rear area warning
system (amber warning lamps, when applicable, and red
tail lamps) must be easily seen by any vehicle operator
coming near the tractor.
Implement warning lamps
(if equipped).
It is recommended that implement warning lamps are
used:
- If the flashing warning lamps and red tail lamps on the
tractor cannot be seen because they are obstructed by
the implement.
- If the towed implement is 1219 mm or more behind the
hitch point of the tractor.
- If the towed implement is 1219 mm or more to the left
or right of the centre of the tractor.
- If the towed implement has a minimum 3000 mm
width.
Install the warning lamps to indicate the side of the imple-
ment nearest the centre of the road.