MCCORMICK X60 Series, Operator'S Manual

Page: 206 / 262

204
Maintenance
500 HOUR MAIN SERVICE
Remove Air From Fuel System - Electronic engine
X60.50
Air can enter the fuel system in the following situations:
A. If the fuel tank becomes empty or is low on fuel.
B. After fuel system parts have been removed for service
or repairs.
C. If the tractor has been in a garage for a long period
of time.
IMPORTANT: DO NOT crank the engine before removing
all the air from the fuel system or the fuel injection pump
can be damaged.
Mod.X60.50
On Mod.X60.50 tractors use the following procedure to
remove air from the fuel system.
OPERATION 1
Make sure there is fuel in the tank.
Turn the key switch to ON to energize the cut off solenoid.
OPERATION 2
Operate the hand primer pump (1) until pressure is felt
against the pump.
OPERATION 3
Start the engine and check for fuel leaks around the filter,
the fuel lines and fittings.
If the engine fails to start operate the hand primer pump
again. If the engine still fails to start see your dealer.
WARNING: Never start the engine in a closed
building. Proper ventilation is required un-
der all circumstances.
WARNING: If you need to open the bonnet, follow the
procedure indicated under “How to open the bonnet”.
Two persons are required to carry out this operation
safely.
Shift the gear to neutral and engage the parking brake.
WARNING: Always use specific personal safety devices
for each operation. Beware of burns caused by hot
water and engine parts.
[4.1.n]