Mazda 2007 CX-9, Service Highlights

Page: 357 / 614

AIR BAG SYSTEM
08-10–5
08-10
End Of Sie
SAS CONTROL MODULE FUNCTION
id081000101000
Sensing Function
•
crash, angular rate, and low-G sensors are built into the SAS control module.
•
If the degree of impact detected by the crash zone sensor and the crash sensor built into the SAS control
module exceeds the set value during a frontal collision to the vehicle, the SAS control module sends an
operation (deployment) signal to the air bag module and the pre-tensioner seat belts.
•
If the degree of impact detected by side air bag sensor No. 1 or No. 2 and the crash sensor built into the SAS
control module exceeds the set value during a side collision to the vehicle, the SAS control module sends an
operation (deployment) signal to the side air bag module and curtain air bag module.
•
During vehicle rollover, the rollover determination is performed based on the results detected by the angular
rate and low-G sensors built into the SAS control module.
Backup Power Supply Function
•
The backup power supply function enables the condenser to discharge and supply power to assure air bag
system operation/deployment properly for a specified time even if the power supply to the SAS control module
is cut due to a collision.
Configuration Function
•
Identifies the variation of the air bag module installed to the vehicle when replacing the SAS control module
with a new one.
•
If the air bag module installed to the vehicle and the module identified by the SAS control module differ, a DTC
is displayed.
•
Refer to the Workshop Manual for the configuration setting procedure.
End Of Sie
3423-1U-06H(08-10).fm 5 ページ ２００６年１１月２２日 水曜日 午後２時５４分