MARMON ANGELO PO BX101E, Technical Manual

Page: 87 / 121

Copyright by Servizio Clienti ANGELO PO Spa
87
5.1.3. Recommended procedure
1. Activate the Clean Test.
2. Proceed directly to the activation of STEP 3.
3. Check on the display the level sensor switches its status from OFF to ON.
4. Check the pressure of the rinse circuit (min 1.5 - max 2.0 bar).
5. Check for leaks along the entire circuit.
6. Proceed directly to the END of the test.
7. At this point the tank is under pressure, so check that the level remains at least for
one minute.
8. If you see the level go down, check the tightness of the drain valve
9. If everything is fine, start to check the dispensers.
10. Reactivate the Clean Test by going directly to STEP 3
11. Go to STEP 4, checking the level indication on the display and go to END as soon
as it changes from ON to OFF, in this way there will remain a minimum quantity of
water in the tank.
12. Activate STEP 1 and wait for the indication on the display to return to ON, if it does
not occur, check the detergent dispenser (rotation, suction, etc.).
13. Repeat steps 10 and 11
14. Activate STEP 2 and wait for the indication on the display to return to ON, if it does
not occur, check the rinse aid dispenser (rotation, suction, etc.)
15. Go to STEP 4 and wait for the complete emptying of the system.