MARMON ANGELO PO BX101E, Technical Manual

Page: 120 / 121

Copyright by Servizio Clienti ANGELO PO Spa
120
E08
The vacuum probe
has failed.
Press reset
button. Check if
the vacuum
probe is
correctly
connected to the
plug on the
control board.
Connect and
disconnect the
vacuum probe
only when the
oven is not
working. If the
problem
persists, call the
after-sales
service.
Check the vacuum probe. The
resistance value must be about
1100 Ohm at 25°C. The probe is
connected to the terminals 50 and
51 of the panel PCB. Verify the
connector terminals are clean and
be sure to follow the user
instructions.
E09
Exceeded
maximum
temperature
allowed in room
(Probe is set to
315°)
Inform the after-
sales service.
The oven’s
functions are
enabled so
cooking cycles
can be carried
out.
Check the chamber probe, and
check the contactors are not
blocked
E10
Electrical
component
compartment has
overheated.
The oven solves
the problem on
its own.
The oven’s
functions are
enabled so
cooking cycles
can be carried
out.
The chamber heating will be
temporarily disabled. Check the
panel board cooling fan. Remove
and clean the air gratings located
on the front of the oven. This
alarm will be automatically reset
when the temperature drops
down.
E11
Electronic circuit
board diagnostics
tripped.
Inform the after-
sales service.
T
he oven’s
functions are
disabled so no
cooking cycles
can be carried
out.
This alarm will appear in the case
the alarm E10 has not been
removed and the temperature on
PCB has rised up to 69°C. Follow
the above instructions.
E13
Electronic circuit
board diagnostics
tripped.
Inform the after-
sales service.
The oven’s
functions are
disabled so no
cooking cycles
can be carried
out.
Communication failure between
the boards or peripheral devices.
Verify electrical connections.
E13 = Power Board - CPU
E13b= Combustion control board