MARMON ANGELO PO BX101E, Technical Manual

Page: 116 / 121

Copyright by Servizio Clienti ANGELO PO Spa
116
E10
Electrical
component
compartment has
overheated.
The oven solves
the problem on
its own.
The oven’s
functions are
enabled so
cooking cycles
can be carried
out.
The chamber heating will be
temporarily disabled. Check the
panel board cooling fan. Remove
and clean the air gratings located
on the front of the oven. This alarm
will be automatically reset when the
temperature drops down.
E11
Electronic circuit
board diagnostics
tripped.
Inform the after-
sales service.
The oven’s
functions are
disabled so no
cooking cycles
can be carried
out.
This alarm will appear in the case
the alarm E10 has not been
removed and the temperature on
PCB has rised up to 69°C. Follow
the above instructions.
E13
Electronic circuit
board diagnostics
tripped.
Inform the after-
sales service.
The oven’s
functions are
disabled so no
cooking cycles
can be carried
out.
Communication failure between the
boards or peripheral devices. Verify
electrical connections.
E13 = Power Board - CPU
E13b= Combustion control board 1
E14
Electronic circuit
board diagnostics
tripped.
Inform the after-
sales service.
The oven’s
functions are
disabled so no
cooking cycles
can be carried
out.
PCB temperature probe failure.
Replace the power board or the
CPU board.
E14V = CPU
E14Q = power board
E20 Configuration error
Inform the after-
sales service.
The oven’s
functions are
disabled so no
cooking cycles
can be carried
out.
Found inconsistencies between the
type of oven and installed boards.
Verify the installed boards (display,
power board) and devices (inverter
and combustion control), verify
their proper connection on net
cables and repeat the configuration
of the oven.
E27 Gas test failure - - - - - -
See paragraph
“Problems during
the test setup wizard”