MARMON ANGELO PO BX101E, Technical Manual

Page: 24 / 121

Copyright by Servizio Clienti ANGELO PO Spa
24
3.2. Alarm recording MY2016 and BXW models
With the oven on in standby mode ( green
power supply LED on), press “
start/stop
” for 3
seconds to see the last 10 error codes. The first displayed is the last error. By turning the
knob anticlockwise you can see the older alarms. If you press “
time
” you will see the time
starting from the first use of the oven until the alarm happened. The first 2 lines are the
hours and the last line Minutes. The displayed time is the time that the oven was ON
(regardless in Start or in Stop).
3.3. Explanation table
When a component is replaced you must perform the procedures indicated below -
attention: these procedures should be performed after replacement of the component and
in the order listed below.
ITEM REPLACED PROCEDURES TO FOLLOW
CPU board (1) Oven configuration procedure
Gas setup procedure
Power board (2) Oven configuration procedure
Comb. Control board (3) Oven configuration procedure
Note : after replacing one of the items listed above, at the first ignition of the oven you may
see alarms E13 and / or E20. After following the procedures listed in the table the alarms
should no longer appear.