Manitou MLT 961-145 V PLUS L JD ST4 S1, Operator'S Manual

Page: 144 / 180

3 - 36
CHECK Radiator *
CHECK Transmission pressures *
CHECK Steering *
CHECK Steering swivel joints *
CHECK Wear of the brake pads and the brake disk *
CHECK Boom assembly conditions *
CHECK Bearings and articulation rings *
CHECK Rubber hose pipe and piping conditions
CHECK Cylinder conditions (leakage, rods)
CHECK Hydraulic circuit pressures *
CHECK Bearings and articulation rings *
CLEAN/CHECK Air conditioning (OPTIONAL)
CLEANING CONDENSER AND EVAPORATOR COILS
CLEAN THE CONTAINER FOR THE CONDENSATE AND THE DRAINAGE VALVE
COLLECTING COOLANT TO REPLACE FILTER-DRIER
FILLING WITH COOLANT AND CHECKING THE ADJUSTMENT OF THE THERMOSTAT AND PRESSURE SWITCHES
NOTE: When opening the evaporator unit, remember to replace the cover seal.
t
IMPORTANT
t
NEVER TRY TO CARRY OUT MAKESHIFT REPAIRS IN CASE OF FAULTS. TO RECHARGE A CIRCUIT, ALWAYS CONTACT THE DEALER WHO HAS THE SUITABLE SPARE PARTS,
TECHNICAL KNOW-HOW AND THE NECESSARY TOOLS.
In event of the following, contact a doctor.
In case of inhalation, move to fresh air.
In case of skin contact, wash immediately with plenty of water.
In case of frostbite, apply a sterile dressing.
In case of contact with eyes, rinse with clear water for 15 minutes.
IMPORTANT INFORMATION ABOUT THE COOLANT USED
• This product contains fluorinated greenhouse gases covered by the Kyoto Protocol.
• Type of coolant: R134A; it is colourless, odourless and heavier than air. Its GWP (Global Warming Potential) is 1,430.
• Do not allow the gases to escape into the atmosphere. Do not under any circumstances open the circuit, as this could
cause loss of coolant.
-The compressor is equipped with a gauge to check the oil level. Never unscrew this gauge: this would discharge the
circuit. Check the level only when changing the oil.
REPLACE Compressor belt (OPTIONAL air conditioning) *
* Consult your dealer
649100 EN-US-AU (20/05/2019) MLT 961-145 V PLUS L JD ST4 S1