Manitou MLT 961-145 V PLUS L JD ST4 S1, Operator'S Manual

Page: 24 / 180

1 - 20
G - TAKING UP AND SETTING DOWN A HIGH LOAD ON STABILISERS
Depending on the model of telehadler
t
IMPORTANT
t
You must not raise the jib if you have not checked the transverse attitude of the telehadler (
e
INSTRUCTIONS FOR HANDLING A LOAD: D - TRANSVERSE ATTITUDE OF THE
TELEHANDLER).
REMINDER: Make sure that the following operations can be performed with good visibility (
e
OPERATION INSTRUCTIONS
UNLADEN AND LADEN: D - VISIBILITY) �
The stabilisers are used to optimise the telehadler's lifting performance (
e
2 - DESCRIPTION: CONTROL AND COMMAND
INSTRUMENTS) �
POSITIONING THE STABILISERS WITH THE FORKS IN TRANSPORT POSITION (UNLADEN
AND LADEN)
-Set the forks in transport position in front of the elevation �
-Stay far enough away to have room for the jib to be raised �
-Apply the parking brake and place the forward/reverse selector in neutral �
-Set the two stabilizers on the ground and lift the two front wheels of the telehadler
(fig � G1), while maintaining its transverse stability �
RAISING THE STABILISERS WITH THE FORKS IN TRANSPORT POSITION (UNLADEN AND
LADEN)
-Raise both stabilizers fully and at the same time �
LOWERING OF STABILISERS WITH JIB UP (UNLADEN AND LADEN)
t
IMPORTANT
t
This operation must be exceptional and performed with great care.
-Raise the jib and retract the telescopes completely �
-Set the telehadler in position in front of the elevation (fig � G2) moving very slowly
and carefully �
-Apply the parking brake and place the forward/reverse selector in neutral �
-Move the stabilizers very slowly and gradually as soon as they are close to the
ground or in contact with it �
-Lower the two stabilizers and lift the two front wheels of the telehadler (fig � G3) �
During this operation, transverse attitude must be permanently maintained: the
bubble in the level must be kept between the two lines �
SETTING THE STABILISERS WITH THE BOOM UP (UNLADEN AND LADEN)
t
IMPORTANT
t
This operation must be exceptional and performed with great care.
-Keep the jib up and retract the telescopes completely (fig � G3) �
-Move the stabilisers very slowly and gradually as soon as they are in contact with
the ground and when they leave the ground � During this operation, the transverse
attitude must be permanently maintained: the bubble in the level must be kept
between the two lines �
-Raise both stabilizers completely �
-Release the parking brake and reverse the telehadler (1) very slowly and carefully,
to release it and lower the forks (2) into transport position (fig � G4) �
G1
G2
G3
1
2
G4
649100 EN-US-AU (20/05/2019) MLT 961-145 V PLUS L JD ST4 S1