Manitou MLT 961-145 V PLUS L JD ST4 S1, Operator'S Manual

Page: 35 / 180

1 - 31
BRINGING THE TELEHANDLER BACK INTO SERVICE
-Remove the waterproof adhesive tape from all the holes �
-Refit and reconnect the battery �
-Remove the protection from the cylinder rods �
-Carry out daily maintenance (
e
3 - MAINTENANCE: 10 HOUR - DAILY MAINTENANCE OR EVERY 10 HOURS OF SERVICE) �
-Put the handbrake on and remove the axle stands �
-Empty and clean the fuel tank (
e
3 - MAINTENANCE: 1000 HOUR - PERIODIC MAINTENANCE - EVERY 1000 HOURS OF
SERVICE OR EVERY 2 YEARS)
-Fill the fuel tank with clean diesel filtered through the filler port �
-Replace the fuel filter (
e
3 - MAINTENANCE: 500 HOUR - PERIODIC MAINTENANCE - EVERY 500 HOURS OF SERVICE OR
EVERY 1 YEAR) �
-Replace the fuel pre-filter (
e
3 - MAINTENANCE: 500 HOUR - PERIODIC MAINTENANCE - EVERY 500 HOURS OF SERVICE
OR EVERY 1 YEAR) (according to model of telehadler) �
-Drain and rinse the DEF tank (according to model of telehadler) �
-Slowly fill the tank with new “DEF” (Diesel Exhaust Fluid) up to the bottom of the filler neck (according to model of telehadler) �
-Refit and set the tension in the drive belts (
e
3 - MAINTENANCE: FILTER CARTRIDGES AND BELTS) �
-Turn the engine over with the starter, to allow the oil pressure to rise �
-Reconnect the engine cut-off solenoid �
-Grease the telehadler completely (
e
3 - MAINTENANCE: 50 HOUR - WEEKLY MAINTENANCE OR EVERY 50 HOURS OF
SERVICE) �
t
IMPORTANT
t
Ensure the area is sufficiently ventilated before starting the telehadler.
-Start up the telehadler, following the safety instructions and regulations (
e
OPERATING INSTRUCTIONS UNLADEN AND
LADEN) �
-Run all the jib's hydraulic movements, concentrating on the ends of travel for each cylinder �