Magnetek IMPULSE VG+ Series 3, Instruction Manual, Page: 20 / 183

IMPULSE•VG+ Series 3 Instruction Manual - 07/25/05
2-7
7. Lay out the wire runs. Size the wire according to NEC Table 610-14(a). At a minimum, use #16
AWG for control wiring and #12 AWG for power wiring. When performing this step:
• Ensure that the drive control circuit and power circuit wires are perpendicular to each other
at any point they cross.
• Keep power and control festoon wiring in separate cables.
• Separate control drive circuit and power circuit wiring on the terminal block strip.
8. Obtain the appropriate hardware for mounting.
9. Mount the subpanel or surface to which you are mounting the drive. (Contact Electromotive
Systems if you need advice on mounting, especially for larger drives.)
10. Fasten the drive and components to the subpanel.
11. Remove the terminal cover.
12. Follow the wiring practices outlined in Chapter 3.