Magnetek IMPULSE VG+ Series 3, Instruction Manual

Page: 179 / 183

IMPULSE•VG+ Series 3 Instruction Manual – 07/25/05
A-10
H6-06 Pulse Input Select 2 5-78
H6-07 Pulse Input Scale 1440 5-78
L1-01 Motor Overload Fault Select 3 5-79
L1-02 Motor Overload Time Constant 8.0 5-79
L1-03 Motor Overheat Alarm Select 3 5-79
L1-04 Motor Overheat Fault Select 2 5-79
L1-05 Motor Temperature Input Filter 0.20 5-79
L2-01 Power Loss Ride Thru Enable/Disable 0 5-80
L2-02 Power Loss Ride Thru Time --- 5-80
L2-03 Power Loss Base Block Time --- 5-80
L2-04 Power Loss Voltage Recovery Time --- 5-80
L2-05 Under Voltage Fault Level 190 5-80
L3-04 Stall Prevention Decel Select 0 5-80
L4-01 Speed Agree Level 0.0 5-80
L4-02 Speed Agree Width 2.0 5-80
L4-03 Speed Agree Level +/- 0.0 5-81
L4-04 Speed Agree Width +/- 2.0 5-81
L6-01 Torque Detection 1 Select 0 5-82
L6-02 Torque Detection 1 Level 150 5-83
L6-03 Torque Detection1 Time 0.1 5-83
L6-04 Torque Detection 2 Select 0 5-84
L6-05 Torque Detection 2 Level 150 5-84
L6-06 Torque Detection 2 Time 0.1 5-84
L8-02 Over Heat Pre-Alarm Level 95 5-85
L8-03 Over Heat Pre-Alarm Select 4 5-85
L8-05 Input Phase Loss Detection 1 5-85
L8-07 Output Phase Loss Detection 2 5-85
L8-09 Ground Fault Detection 1 5-85
L8-10 Fan on/off Selection 0 5-85
L8-11 Fan Delay Time 60 5-85
L8-12 Ambient Temperature 45 5-85
L8-15 OL2 Selection at Low Speed 0 5-85
L8-18 Software Current Limit 1 5-85
L9-01 Auto Reset Enable/Disable 1 5-86
L9-02 Reset Attempts 3 5-86
L9-03 Reset Time 0.5 5-86
L9-04 Reset Fault Select 1 0001 5-86
L9-05 Reset Fault Select 2 0080 5-86
L9-06 Fault Contact Operation at Reset 0 5-86
O1-01 User Monitor Select 6 5-88
O1-02 Power On Monitor 2 5-89
O1-03 Display Scaling 0 5-89
O1-04 Display Units 0 5-89
O1-05 LCD Contrast 3 5-89
O2-01 Mode/Service Key 0 5-90
No. Parameter Name. Factory Ref Page#.