20
2.2
DRIVE MODE OPERATION.
A)
This
flow chart
shows the
display
items in the
Drive mode
after the
power
supply is
turned on.
Press
DSPL
key to cycle.
B)
Frequency Reference Display.
Frequency reference is displayed in units of
0.1 Hz. See paragraph 1.7 to change frequency reference.
C)
Output Frequency Display.
Output frequency is displayed in units of 0.1 Hz.
The far left digit indicates the rotating direction while running
(blank = forward; "
–
" = reverse).
D) Output Current Display.
Output current is displayed in units of 0.1 Amp.
2.3
PROGRAM MODE OPERATION.
IMPORTANT
Constant
no-00
determines which constants can
be read or set. Therefore, it should always be the
first constant read, and set if necessary.
Constants are read /set in the Program mode by the following
procedures:
POWER UP
FREQUENCY REFERENCE DISPLAY
OUTPUT FREQUENCY DISPLAY
OUTPUT CURRENT DISPLAY
CONSTANT DISPLAY / READING
( SETTING NOT POSSIBLE )
Press DSPL
Press DSPL
Press DSPL
Press DSPL
F 0 6 0 . 0
– 0 6 0 . 0
I 0 . 0 A
efesotomasyon.com - Yaskawa ac drive,servo motor
Summary of Contents for GPD 333
