Magnetek GPD 333, Technical Manual

Page: 77 / 81

63
APPENDIX 2 GPD 333 SPARE PARTS
MagneTek does not offer spare parts for the GPD 333. Because
of the compact size of the drive and the inherent difficulty of
properly installing replacement parts, MagneTek recommends
changing out the complete drive unit if troubleshooting deter-
mines that it is defective.
A MagneTek authorized repair shop may be able to repair a
defective drive, but this would necessitate longer down-time.
When changing out a drive unit, make sure that any of the fol-
lowing separately priced options are transferred to the replace-
ment unit, unless they are already present on the replacement
unit:
– Attached to control terminals:
• 24 Vdc Interface board
• 115 Vac Interface board
• Auxiliary Potentiometer Card
– Attached to heat sink:
• Din Rail Mount
– Mounted on front of drive:
• Digital Operator (DS039) [ Note: This is a standard
part of a NEMA 4/12 GPD 333; therefore, DO
NOT remove it. ]
• Remote Interface Panel (DS090)
• Analog Speed Input board (DS091)
• Any serial communication intereface board
(NCL/Modbus Plus, DeviceNet, SDS, etc.)
NOTE: If the defective GPD 333 has Modbus RTU interface (a
factory installed option), the replacement GPD 333 must also
have the interface factory installed.
Be sure to program the replacement drive unit as required for
installed options; see their separate instruction sheets, which
should already be on hand.
efesotomasyon.com - Yaskawa ac drive,servo motor